When powered up the TravelSafe alarm will automatically perform a self-test.
If the test where passed, all three LED´s will indicate that, by flashing 3 times, furthermore a beep will sound .
In the other case, if an error was encountered, the red LED will indicate the type of error.
This is done by flashing red LED x times according to the number of the error.
(If more than one error is present – only the first error encountered is indicated on the LED).
1 x flash – failure on button
2 x flash – failure on low voltage (battery)
3 x flash – LED failure (red, green, yellow LED)
4 x flash – failure on light sensor in smoke chamber
5 x flash – failure on system voltage
6 x flash – motion sensor failure
Travel Alarm – failure schematics
on May 24, 2019
with
No Comments
Comment on this FAQ